HP 4284A - Page 279

LIST Subsystem
:BAND < n >
The :BAND < n > command sets the limit values of the limit function
for the list sweep measurement. The :BAND < n > ? query returns the
current limit value settings.
Command Syntax
LIST:BAND < n >< parameter >
2
, < low limit n > , < high limit n >
3
Where,
< n > 1 to 10 (NR1) : Sweep pointnumber
< parameter > is : A Limit setting enable for primary parameter
B Limit setting enable for secondary
parameter
OFF Limit setting disable
< low limit n > NR1, NR2, or NR3 format : low limit for sweep
point < n >
< high limit n > NR1, NR2, or NR3 format : high limit for sweep
point < n >
Example
OUTPUT 717;"LIST:BAND1 A,10,20"
OUTPUT 717;"LIST:BAND3 OFF"
Query Syntax
LIST:BAND < n > ?
Query Response
Returned format is :
< parameter > , < low limit n > , < high limit n >
Example
10 DIM A$[30]
20 OUTPUT 717;"LIST:BAND3?"
30 ENTER 717;A$
40 PRINT A$
50 END
8-38 Command Reference