HP 4284A - Page 291

MEMory Subsystem
:CLEar
The :CLEar command clears the data buer memory. After
execution of this command, measurement data will not b e stored in
the data buer memory until execution of the :FILL command. For
details, refer to \Data Transfer" in Chapter 7.
Command Syntax
MEMory:CLEar DBUF
Example
OUTPUT 717;"MEM:CLE DBUF"
:READ?
The :READ? query places the data in the data buer memory into the
output buer. If the data buer memory is not lled to the sp ecied
size (sp ecied by the :DIM command), the data lo cations in which
data is not stored will b e set to
0 1 (no data). For details of the
returned data format, refer to \Data Transfer" in Chapter 7.
Query Syntax
MEMory:READ? DBUF
Example
OUTPUT 717;"MEM:READ? DBUF"
8-50 Command Reference