HP 4284A - Page 312

:Secondary LIMit
:Secondary LIMit
The :Secondary LIMit command sets the low/high limit values for
the comparator function secondary parameter. The :Secondary
LIMit? query returns the current settings of the secondary
parameter low/high limit values.
Command Syntax
COMParator:SLIMit < low limit > , < high limit >
Where,
< low limit > is the NR1, NR2, or NR3 format : low limit value
< high limit > is the NR1, NR2, or NR3 format : high limit value
Note
The low limit value should b e lower than the high limit value. If the
low limit value is set higher than the high limit, a warning message is
displayed when this command is received (an error do es not o ccur).
Example
OUTPUT 717;"COMP:SLIM 0.001,0.002"
Query Syntax
COMParator:SLIMit?
Query Response
Returned Format is:
<NR3>,<NR3><NL^END>
Example
10 OUTPUT 717;"COMP:SLIM?"
20 ENTER 717;A,B
30 PRINT A,B
40 END
Command Reference 8-71