Setting accuracies apply when the bias current isolation function is
set to OFF. When the bias current isolation function is set to ON,
add
6
20 mV to each accuracy value (DC bias current
1
A).
Bias Current Isolation Function
A maximum DC bias current of 100 mA (typical value) can b e
applied to the DUT.
DC Bias Monitor Terminal
Rear panel BNC connector
Other Options
Option 002 Bias CurrentInterface
Allows the HP 4284A to control the HP 42841A Bias
Current Source.
Option 006 2 m/4 m Cable Length Op eration
Option 008 Add Operation Manual (Japanese)
Option 009 Delete operation manual
Option 109 Delete HP-IB Interface
Option 201 Handler Interface
Option 202 Handler Interface
Option 301 Scanner Interface
Option 907 Front Handle Kit
Option 908 Rack Mount Kit
Option 909 Rack Flange and Handle Kit
Option 910 Extra Operation Manual
Option W30 3Year Extended Warranty
Furnished Accessories
Operation Manual HP Part Number 04284-90000
Memory Card HP Part Number 04278-89001
Power Cable Depends on the country where the HP 4284A is
being used. Refer to Page 1-6, Figure 1-3
Fuse Only for Option 201, HP Part Number
2110-0046, 2ea.
Power Requirements
Line Voltage
90 to 132 Vac, 198 to 252 Vac
Line Frequency
47 to 66 Hz
Power Consumption
200 VA max.
9-20 General Information
To Next Page
