HP 4284A - Page 420

HP-IB Errors
Error
No.
Error Message String  Description
Command Error
0 100 Command error  Improp er command.
0 101 Invalid character  Invalid character was received.
0 102 Syntax error  Unrecognized command or data type was received.
0 103 Invalid message unit separator  The message unit separator (for example, \ ; ", \ , ") is
improp er.
0 104 Data type error  Improp er data type used (for example, string data was
expected, but numeric data was received).
0 105 GET not allowed  GET is not allowed inside a program message.
0 108 Parameter not allowed  To o many parameters for the command received.
0 109 Missing parameter  A command with improp er numb er of parameters received.
0 112 Program mnemonic to o long  Program mnemonic is to o long (maximum length is 12
characters).
0 113 Undened header  Undened header or an unrecognized command was
received (op eration not allowed).
0 121 Invalid character in number  Invalid character in numeric data.
0 123 Numeric overow  Numeric data value was to o large (exponent magnitude
> 32k).
0 124 To o many digits  Numeric data length was to o long (more than 255 digits
received).
0 128 Numeric data not allowed  Numeric data not allowed for this op eration.
0 131 Invalid sux  Units are unrecognized, or the units are not appropriate.
0 138 Sux not allowed  A sux is not allowed for this op eration.
0 141 Invalid character data  Bad character data or unrecognized character data was
received.
0 144 Character data to o long  Character data is to o long (maximum length is 12
characters).
0 148 Character data not allowed  Character data not allowed for this op eration.
0 150 String data error  String data is improp er.
Error and Warning Messages B-9