EasyManua.ls Logo

HP 4600 - Page 49

HP 4600
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENWW 35
Note The printer display dims when the printer is in PowerSave mode.
PowerSave mode does not affect printer warm-up time.
To set PowerSave Time
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press ✔ to select SYSTEM SETUP.
6. Press to highlight POWERSAVE TIME.
7. Press ✔ to select POWERSAVE TIME.
8. Press or to select the appropriate time period.
9. Press ✔ to set the time period.
10. Press P
AUSE/RESUME.
To disable/enable PowerSave
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight RESETS.
5. Press ✔ to select RESETS.
6. Press to highlight POWERSAVE.
7. Press ✔ to select POWERSAVE.
8. Press or to select ON or OFF.
9. Press ✔ to set the selection.
10. Press P
AUSE/RESUME.