EasyManua.ls Logo

HP 4600 - Page 51

HP 4600
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENWW 37
5. Press ✔ to select SYSTEM SETUP.
6. Press to highlight CLEARABLE WARNINGS.
7. Press ✔ to select CLEARABLE WARNINGS.
8. Press or to select the appropriate setting.
9. Press ✔ to set the selection.
10. Press P
AUSE/RESUME.
Auto continue
You can determine printer behavior when the system generates an
Auto Continuable error. ON is the default setting.
z ON displays an error message for ten seconds before
automatically continuing to print.
z OFF pauses printing any time the printer displays an error
message and until you press ✔.
To set the auto continue
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press ✔ to select SYSTEM SETUP.
6. Press to highlight AUTO CONTINUE.
7. Press ✔ to select AUTO CONTINUE.
8. Press or to select the appropriate setting.
9. Press ✔ to set the selection.
10. Press P
AUSE/RESUME.
Supplies low
The printer allows two options for reporting that supplies are low;
CONTINUE is the default value.
z CONTINUE allows the printer to continue printing while displaying a
warning until the supply is replaced.
z STOP causes the printer to pause printing until you replace the
used supply or press ✔, which allows the printer to print while
continuing to display the warning.