HP 48SX - Page 18

PRTPAR Parameters {delay remap linelength lineterm}
set. Default is null string.
Parameter Description Parameter Description
delay Time (< 6.9 seconds) delay between linelength Print line length. Does not affect IR
printed lines. Default is 1.8 seconds. printing. Default is 80 characters.
remap String that specifies remapping character lineterm String containing line terminating character
sequence. Does not affect IR printing.
Default is carriage-return/line-feed.
Data Transfer
Transferring Data Between Two HP 48s. Before beginning transfer, set IR and binary transfer modes in I/O SETUP
menu ([\)(I/0)] SETUF).
= On sender, go to directory where variables are located.
m On receiver, go to directory that will receive information.
m Position calculators less than 2 inches apart, with IR ports aligned (the A symbols near the HP logo on top of the HP 48
cases should be lined up).