Loading custom-size media in tray 2 or optional tray 3
1. Pull the tray out of the printer and remove any media.
●
If you are printing on longer media from tray 2, slide the lock lever on the tray into the
unlocked position, and then extend the rear section of the tray to fit the media that you are
loading.
Re
le
a
s
e
B5
A3
11x17
Legal
8.5x13
2. Place the media in the tray and make sure that it is flat at all four corners. Keep the stack below
the height tabs on the paper-length guide in the rear of the tray.
Lock
3. On the rear paper-length guide, press the tab and slide it up against the edge of the stack.
Lock
ENWW Printing on special media 77
To Next Page
Loading...