Model 5334A
General Information
I
SECTION I
GENERAL INFORMATION
l-l. INTRODUCTION
l-2. This manual contains the information necessary to install, operate, and program the
Iiewlett-Packard Model 5334A Universal Counter.‘The counter is shown in Figure 7-T with
supplied accessories.
1-3. MANUAL SUMMARY
I-4. This manual is divided into three sections, each covering a particular topic for the oper-
Ation and programming of the HP 5334A. The infprmation contained in each section isdescribed
below.
I
SECTION I, GENERAL INFORMATION: describes the instrument documented by this
manual and covers instrument identification, options, accessories, specifications, recom-
mended test equipment, and other basic information.
SECTION II, INSTALLATION: provides information concerning initial inspection, prepa-
ration for USE (including address selection for remote operation], and storage and
shipment.
SECTION III, OPERATION AND PROGRAMMING: provides information pertaining to
panel features, operating characteristics, operator’s maintenance, and includesoperator’s
checks, operating instructions for local operation and programming instructions for remote
operation via the Hewlett-Packard Interface Bus.
1.5. AdditionalcopiesofthisManualandoftheHP5334AOperatingandServiceManualcan be
ordered through your nearest Hewlett-Packard Sales and Service Office.
l-6. SPEClFlCATlONS
l-7. Instrument specifications are listed in Table
1-1.
These are the performance standards, or
limits against which the instrument may be tested including typical characteristics asadditional
information for the user.
I
1-8. SAFETY CONSIDERATIONS
l-9. The 5334A Universal Counter isa Safety Class I instrument (provided with a protective earth
terminal], designed according to international safety standards. Safety information pertinent to
the operation and servicing of this instrument is located in appropriate sections of this manual
including cautions and warnings which must be followed by the user to enwrc safe operation
and keep the instrument in safe condition.
l-10.
GENERAL
1.11. This product and related documentation must be reviewed for familiarization with safety
markingsand instructions before operation. Beforeapplyingpower,verifythat the product isset
to match the available line voltage and the correct fuse is installed. Refer to Section II,
Installation.
1-1 I
To Next Page
Loading...