6. If it is necessary to replace the webcam/microphone module:
a. Detach and release the module (1) as far as the module cable allows. (The module is
attached to the display enclosure with double-sided tape.)
b. Disconnect the module cable (2) from the module.
c. Remove the webcam/microphone module (3). The webcam/microphone module is available
using spare part number 646138-001.
7. If it is necessary to replace the hinge covers:
a. Remove the two Phillips PM2.5×5.0 (1) screws that secure the hinge covers to
the display enclosure.
70 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
