HP
8
1533B
and Optical Heads
Performance
Tksts
Introduction
The procedures in this section test the electrical performance of the instrument.
The complete specifications to which the HP 81533B, with an optical head, is
tested are given in Appendix
C.
All tests can be performed without access to
the interior of the instrument. The test equipment given corresponds to tests
carried out with Diamond HMS-lO/HP connectors.
%st Record
Results of the performance test may be tabulated on the Test Record provided
after the test procedures. It is recommended that you a1 out the Test Record
and refer to it while doing the test. Since the test limits and setup information
are printed on the Test Record for easy reference, the record can also be used
as
an abbreviated test procedure (if you are already familiar with the test
procedures). The Test Record can also be used as a permanent record and may
be reproduced without written permission from Hewlett-Packard.
%st Failure
If the HP 81533B or the optical head fails any performance test, return it to the
nearest Hewlett-Packard SalesIService Office for repair.
HP
81533B
and Optical Heads Performance Tests
D-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
