10
CPU Upgrade
Installation Verification
Installation Verification
Before performing the procedures in this section, make sure that all cover plates removed are reinstalled
and secure. This is for proper seating of the cards, as well as, cooling requirements.
1. Connect the power cord to the rear of the computer.
2. Insert the computer key into the switch and turn it to the ON position.
3. Observe the Front Panel Display and Console for any error or fault (FLT) messages (see CPU Fault
Messages). Verify the number of CPUs shown in the Front Panel Display.
4. When the console displays the following message:
To override, Press any key within 10 seconds
Press a key to interrupt boot.
5. The PDC Main Menu will be displayed (the appearance of the menus may vary slightly, depending
upon your installed version of the PDC):
-------- Main Menu ---------------------------------------------
Command Description
BOot [P
RI|AL
T|<path>]
Boot f
rom specif
i
ed path
P
Ath [PRI|AL
T|CON|KEY] [<path
>]
Display or modify
a path
SEArch [DIsplay|IPL] [
<path>]
Search for boo
t de
vices
COnfiguration menu Displays or sets boot values
INformation menu Displays hardware information
SERvice menu Displays service commands
DIsplay Redisplays the current menu
HElp [<menu>\<command>] Display help for menu or command
RESET Restart the system
---------
Main Menu: Enter command or menu > in
To Next Page
Loading...
Need help?
General
