HP Color LaserJet CP1210 Series; Color LaserJet CP1510 Series - Page 130

3. HP Color LaserJet CP1210 Series Printer: Disconnect one FFC (callout 1), and then remove one
screw (callout 2).
Figure 6-27 Remove the control-panel module (1 of 4)
1
2
or
HP Color LaserJet CP1510ni only: Disconnect one FFC (callout 3), one wire-harness connector
(callout 4), and then remove three screws (callout 5).
TIP: The top-most memory-card bracket mounting screw is a self-tapping screw. When
reinstalling the control-panel module, make sure that you replace this screw in the correct position
in the product.
Figure 6-28 Remove the control-panel module (2 of 4)
3
4
5
112 Chapter 6 Removal and replacement ENWW