Internal assemblies
Main motor
1. Remove the right cover. See Right cover on page 103.
2. Disconnect one wire-harness connector (callout 1), and then release two tabs (callout 2) to release
the retainer (callout 3). Slide the retainer down and separate it from the chassis.
Figure 6-44 Remove the main motor (1 of 2)
3
2
1
3. Remove four screws (callout 4), and then remove the main motor.
Figure 6-45 Remove the main motor (2 of 2)
4
122 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...