NOTE: The HP Color LaserJet CP1210 Series Printer does not have a memory-card reader.
●
Rear-side cover. See
Rear-side cover on page 115.
●
Rear-upper cover. See
Rear-upper cover on page 116.
●
Top cover. See
Top cover on page 119.
2. Release two tabs (callout 1) and then remove the protective cover (callout 2).
Figure 6-59 Remove the DC controller PCA (1 of 3)
1
2
3. Disconnect all of the FFCs and wire-harness connectors from the DC controller PCA.
●
Three FFCs: J107, J108, and J115
●
Wire harness
◦
HP Color LaserJet CP1210 Series Printer: 14 wire-harness connectors: J012, J104,
J105, J109, J110, J111, J112, J113, J116. J118, J119, J120, J121, and J124
NOTE: J117, J126, and J127 are not used.
◦
HP Color LaserJet CP1510 Series Printer: 15 wire-harness connectors: J012, J104,
J105, J109, J110, J111, J112, J113, J116, J117, J118, J119, J120, J121, and J124
132 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...