PPDs, Macintosh 12
pre-troubleshooting checklist 156
preservice checklist 92
primary charging stage 81
print cartridges
error messages 177, 182
image-formation system 80
low or out, settings 24
non-HP 62, 177
order message 177, 182
recycling 63, 251
removing 95
replace message 177, 182
replacing 63
status, viewing with HP
ToolboxFX 39, 49
storage 62
supplies status page 22
warranty 242
print cartridges, accessing 5, 7
print density settings 44, 54
print media
supported 28, 30
print quality
archive setting 26
HP ToolboxFX settings 44,
54
repetitive image defects 160
print quality, troubleshooting
image defects 193
print-quality test 93
printing
troubleshooting 199
Product information tab, HP
ToolboxFX 40, 50
product registration 47, 57
production code 6, 8
protocols, networks 15
PS font list 22
Q
quality
archive setting 26
HP ToolboxFX settings 44,
54
repetitive image defects 160
R
rear door and rear-lower cover,
removing 117
rear door, locating 5, 8
rear-side cover, removing 115
rear-upper cover, removing 116
recommended software
installation 10
recycling
HP printing supplies returns and
environmental program 252
recycling supplies 63
registration, product 47, 57
remote firmware upgrades
about 70
removing parts
cautions for 90
checklists 92
control-panel module 111
DC controller PCA 131
formatter PCA 134
front doors 107
fuser 149
left cover 105
memory-card reader 111
order of 94
pickup roller 96
power supply (fuser) 146
power supply (high-
voltage) 136
power supply (low-
voltage) 140
print cartridges 95
rear door and rear-lower
cover 117
rear-side cover 115
rear-upper cover 116
right cover 103
separation roller 98
tools, required 90
top cover 119
repacking the product 244
repetitive defects,
troubleshooting 160, 196
replace supplies message 177,
182
replaceable parts 209
replacing
fuser motor 123
ITB 124
main motor 122
parts 90
replacing print cartridges 63
reports
error 203
event log 184
service 203
Reports menu 22
resets
cold 203
NVRAM initialization 204
resolution
features 3
specifications 3
restoring
defaults 202
factory defaults 202
restoring default settings
cold reset 203
NVRAM initialization 204
revision level 6, 8
right cover, removing 103
ro
l
lers
image formation
operations 81
locating 167
repetitive image defects 160
rollers, pickup and separation;
removing 96
S
safety statements 255, 256
scatter, troubleshooting 196
screwdrivers, required 90
screws
part numbers 211
replacing 90
secondary service menu 202
sensors
jam detection 88
location 166
separation roller, removing 98
separation rollers
locating 167
separation stage, image
formation 84
sequence of operations 74
serial number 6, 8
service
information form 245
repacking the product 244
tools, required 90
service error message 180
ENWW Index 263
To Next Page
Loading...