IPv6 Configuration
Use the IPv6 Configuration page to configure the IP address and host and domain names for the
printer.
Figure 2-97 HP EWS, Networking tab – IPv6 Configuration page
Network Identification
Use the Network Identification pane to configure the Host name and Domain name(s) used to identify
the device on the network.
The values for Host name and Domain names are retrieved from the firmware, and displayed on this
pane. The Networking firmware determines what Host name and Domain name(s) to use.
The information under Available Host name / Domain names is for information only and cannot be
modified.
The text entries are disabled under certain circumstances. The following table defines when the entities
are disabled:
Table 2-11 Network Identification pane – Text Entities
Text Entity Disabled status
Host name Disabled if configured by BOOTP
Domain name (IPv4/IPv6) Disabled if configured by BOOTP, DHCPv4, or DHCPv6
ENWW HP Embedded Web Server 111
Software Description
To Next Page
Loading...