NOTE: Certain software programs can override the size command and specify different media sizes
within a single document.
When you change the print-driver setting to a media size that is not currently loaded in the printer, a
control-panel message prompts you to load the media size or select another tray.
Custom Paper Size
The Custom Paper Size dialog box appears when you click Custom… on the Paper/Quality tab.
The following figure shows the initial appearance of the Custom Paper Size dialog box.
Figure 4-8 Print/Quality tab – Custom Paper Size dialog box
Name
Use the Name text box to type a new name for a custom media size.
The name that appears in the Name text box depends on the following conditions:
●
If a saved custom media size has been selected from the drop-down menu on the Paper/
Quality tab, the Name text box shows the name of the selected custom media size.
●
If a standard media size has been selected on the Paper/Quality tab, the Name text box shows
the default name of "Custom."
●
If a new name has been typed into the Name text box for the purpose of saving a new size or
renaming an existing size, then that new name will remain in the text box until the new size is saved
or the dialog box is closed.
If you type a new name into the Name text box, but then do not click Save, you can change the width
and height values without losing the name. However, if you close the dialog box without clicking Save,
any unsaved name or size values are lost without warning.
ENWW Paper/Quality tab features 191
HP PCL 6, PS emulation
drivers, and UPD for
Windows
To Next Page
Loading...