4. Insert the stack of even-number pages that just printed when the control panel shows the Manually
Feed message (or it shows the Load Tray message), insert the stack of media (on which the even-
numbered pages have been printed).
Figure 4-22 Finishing tab – Print on Both Sides instruction windodw
5. Click the OK button on the printer control panel.
6. The odd numbered pages print on the second side (blank) of the stacked sheets.
NOTE: For more assistance, refer to animation in the Help section of the HP ToolboxFX.
Flip Pages Up option
Select the Flip Pages Up check box to specify the duplex-binding option. (The Flip Pages Up option
is only available when Print on Both Sides (Manually) is selected.) By default, the Flip Pages Up
check box is not selected. The following table shows the results of selecting this box, depending on the
paper orientation selected on the Finishing tab.
Table 4-12 Page orientation
Orientation (Finishing tab) Flip Pages Up selected Flip Pages Up not selected
Portrait Short-edge binding Long-edge binding
Landscape Long-edge binding Short-edge binding
When Print on Both Sides (Manually) is selected, the document preview image changes to show a
spiral binding along either the left edge or the top edge of the page. In addition, a folded-over corner
appears in the lower-right portion of the preview image, indicating that printing occurs on the back side.
ENWW Finishing tab features 211
HP PCL 6, PS emulation
drivers, and UPD for
Windows
To Next Page
Loading...