●
Output Protocol
●
Send Ctrl-D Before Each Job
●
Send Ctrl-D After Each Job
●
Convert Gray Text to PostScript Gray
●
Convert Gray Graphics to PostScript Gray
●
Add Euro Currency Symbol to PostScript Fonts
●
Job Timeout
●
Wait Timeout
●
Minimum Font Size to Download as Outline
●
Maximum Font Size to Download as Bitmap
●
Postscript Passthrough
●
JPEG Passthrough
Available PostScript Memory
This control specifies the amount of available postscript memory and provides a spin box for changing
this value. The available postscript memory is a subset of the printer's total physical memory. It is usually
best to set the postscript memory to match the total RAM that appears on the configuration page.
To print a configuration page from the printer control panel, follow these steps:
1. Press OK to open the menus.
2. Press the Left arrow or Right arrow button to navigate to Main menu/Reports. Press OK.
3. Press the Left arrow or Right arrow button to navigate to Reports/Config report. Press OK to
print the configuration report.
Output Protocol
This control specifies the protocol that the printer uses for print jobs. The following options are
available:
●
ASCII (default)
●
TBCP
●
Binary
Click ASCII to send data in ASCII format (7-bit), which might take longer to print but can be sent through
any I/O channel, such as a serial or network port.
Click TBCP (Tagged Binary Communications Protocol) to send all data except special control characters
in binary (8-bit) format. The binary formats can be sent over serial communications ports and are faster
than sending data in ASCII format.
Click Binary to send all data except special control characters in binary (8-bit) format. The binary formats
can be sent over serial communications ports and are faster than sending data in ASCII format.
230 Chapter 4 HP PCL 6, PS emulation drivers, and UPD for Windows ENWW
HP PCL 6, PS emulation
drivers, and UPD for
Windows
To Next Page
Loading...