USB software installation
Use a USB cable to connect a single computer directly to the product.
This product supports a USB 2.0 connection. You must use an A-to-B type USB cable that is no
longer than 2 m (6.5 ft).
CAUTION: Do not connect the USB cable until the installation software prompts you to connect it.
Windows
1. Quit all open programs on the computer.
2. Install the software from the CD, and follow the onscreen instructions.
3. When the software prompts you, connect the USB cable to the product and the computer.
4. Print a page from any program to make sure that the software is correctly installed.
NOTE: If the installation failed, reinstall the software.
Mac
1. Install the software from the CD.
2. Click the product icon, and follow the onscreen instructions.
3. When the software prompts you, connect the USB cable to the product and the computer.
4. Print a page from any program to make sure that the software is correctly installed.
NOTE: If the installation failed, reinstall the software.
ENWW USB software installation 5
EN
7
To Next Page
Loading...
