Hardware Reference Guide 2–5
Battery Replacement
Type 2:
a. To release the battery from its holder, push the retaining clip
that holds the battery in place 1.
a. Lift the battery out of its holder 2.
Removing a Type 2 Battery
b. Slide the replacement battery into position. The battery
holder automatically secures the battery in the proper
position.
✎
After the battery has been replaced, use the following steps to
complete this procedure.
5. Replace the computer cover or access panel.
6. Plug in the computer and turn on power to the computer.
Reset the date and time, your passwords, and any special system
setups, using Computer Setup. Refer to the Computer Setup (F10)
Utility Guide.
To Next Page
Loading...
Need help?
General