3. Disconnect the following cables from the system board:
(1) Speaker cables
(2) Microphone cable
(3) Fan cable
(4) Power cable
(5) Display panel cable
4. Remove the two Phillips PM1.6×2.5 screws (1) that secure the actuators for the power switch and
wireless on/off switch to the system board.
5. Remove the actuators (2).
NOTE: The actuators are included in the Bracket Kit, spare part number 507318-001.
6. Remove the two Phillips PM2.0×3.0 screws (1) that secure the USB connector bracket to the base
enclosure.
Component replacement procedures 55
To Next Page
Loading...
