4.
Remove the display assembly (2).
5. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a.
Remove the two display bezel screw covers (1) and the two Phillips PM2.5×5.5 screws (2)
that secure the display bezel to the display assembly. The display bezel screw covers are
available in the Rubber Kit, spare part number 686276-001.
b. Flex the inside edges of the bottom edge (3), the left and right sides (4), and the
top edge (5) of the display bezel until the bezel disengages from the display enclosure.
68 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
