To change the settings, make your selections by using the drop-down menus in the Manual Color
Options dialog box, and then click the OK button.
Figure 3-17 Manual Color Options
The Color Settings dialog box gives you independent control of the following settings:
●
Text
●
Graphics
●
Photographs
●
General
Text, Graphics, and Photographs sections
Use these sections to control the Neutral Grays setting for each control.
Neutral Grays
The Neutral Grays drop-down menu controls the selection of a device-dependent color table that is
embedded in the printer firmware. The options are Black Only or 4-Color. You can adjust the Neutral
Grays setting independently for Text, Graphics, or Photographs.
●
Black Only. Generates neutral colors (grays and black) by using only black toner. This option
guarantees that neutral colors do not have a color cast. Black Only is the default setting for the
Text and Graphics components.
●
4-Color. Generates neutral colors by combining all four colors of toner, which produces smoother
gradients and transitions to non-neutral colors, and produces the darkest possible black. 4-Color
is the default setting for Photographs.
90 Chapter 3 HP Color LaserJet CP1210 Series print driver (Host-based raster driver) ENWW
To Next Page
Loading...