System Setup
Use the System Settings options to configure miscellaneous printer settings.
●
Jam recovery. If this option is on, the printer automatically reprints pages that are damaged when
a jam occurs. The default is Off.
●
Auto continue. If this setting is Off, the printer waits indefinitely for you to respond to prompts that
require action. If this setting is On, the printer continues printing after a specific length of time, even
if you have not responded to the prompt. The default is Off.
●
Sleep time-out. Specify the length of time, in minutes, for the printer to enter Sleep mode, after
no activity has occurred. The default is 1 minute.
●
Cartridge out override. Set the option of whether to continue printing after a cartridge has reached
the threshold for end of life. The default is Off.
●
Location. Select the appropriate country/region. The default is country/region specific.
NOTE: You must click the Apply button before your changes will take effect.
Figure 1-12 HP Color LaserJet CP1210 Series Toolbox — System Setup screen
24 Chapter 1 Purpose and scope ENWW
To Next Page
Loading...