3. Rotate the roller shaft down and away from the product, and then slide the roller toward the rear
of the product to release the front of the roller shaft.
Figure 6-22 Remove the pickup roller (Tray 2) (3 of 4)
4. Remove the pickup roller.
Reinstallation tip Make sure that the roller is orientated correctly when it is reinstalled (the large
white collar should be positioned toward the front of the product.
Figure 6-23 Remove the pickup roller (Tray 2) (4 of 4)
ENWW Customer self repair (CSR) components 181
To Next Page
Loading...