4. Remove one screw (callout 7), and then remove the cover (callout 8).
Figure 6-163 Remove the laser/scanner assembly (Y/M) (4 of 12)
8
7
5. Disconnect one FFC (callout 9), and then release one spring (callout 10).
CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of
needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade screwdriver
to remove the spring; the spring could forcibly leave the product and strike you.
Reinstallation tip When you reinstall the spring, make sure that the laser/scanner fits tightly up
against the product chassis, and make sure that the FFC is fully seated in the connector. The
locator tabs on the front and rear of the scanner must be firmly seated in the slots in the chassis.
Figure 6-164 Remove the laser/scanner assembly (Y/M) (5 of 12)
10
9
ENWW Internal assemblies 267
To Next Page
Loading...