8. Pull the fan assembly slightly out of the product, disconnect two connectors (callout 13), and then
remove the assembly.
Figure 6-167 Remove the laser/scanner assembly (Y/M) (8 of 12)
13
9. Remove one screw (callout 14), and then release one spring (callout 15).
CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of
needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade screwdriver
to remove the spring; the spring could forcibly leave the product and strike you.
Reinstallation tip When the laser/scanner is properly positioned in the chassis, the plastic parts
which protrude at the front and rear of the product will be firmly seated against the locator tabs on
the chassis. Verify that the assembly is correctly seated, and then install the spring.
Figure 6-168 Remove the laser/scanner assembly (Y/M) (9 of 12)
15
14
ENWW Internal assemblies 269
To Next Page
Loading...