4. Check the control-panel display for a sensor response.
5. If there is no response, replace fuser. See
Fuser on page 179.
D fuser (fixing) delivery sensor
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the fuser assembly, and then verify that the sensor flag on the fuser assembly moves
freely. If the sensor flag does not move freely, replace the fuser. See
Fuser on page 179.
Figure 7-7 Test the fuser delivery sensor (1 of 2)
4. Insert a piece of paper to activate the fuser (fixing) delivery sensor.
Figure 7-8 Test the fuser (fixing) delivery sensor (2 of 2)
ENWW Tools for troubleshooting 327
To Next Page
Loading...