5. Check the control-panel display for a sensor response.
6. If there is no response, replace the fuser (fixing) delivery sensor.
E duplex re-pickup sensor
1. Open the right door.
2. Use the green handle to lift the duplex jam cover.
3. Insert a piece of paper to activate the duplex re-pickup sensor (8492).
Figure 7-9 Test the duplex re-pickup sensor
4. Check the control-panel display for sensor response.
5. If no response, replace the right door assembly. See
Right-door assembly on page 194.
F output bin full sensor
NOTE: Upper-front cover has been removed for clarity.
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the fuser.
328 Chapter 7 Solve problems ENWW
To Next Page
Loading...