4. Move the output-bin full sensor flag.
Figure 7-10 Test the output-bin-full sensor
5. Check the control-panel display for sensor response.
6. If no response, remove the control panel and verify that the flag is moving. If not, replace the delivery
assembly. If the sensor is malfunctioning, replace the delivery assembly. See
Delivery assembly
on page 303.
H fuser (fixing) pressure-release sensor
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the fuser, and then rotate the gear (callout 1) to move the flag (callout 2). If the flag does
not actuate, replace the fuser. See
Fuser on page 179.
Figure 7-11 Test the fuser (fixing) pressure-release sensor (1 of 2)
2
1
ENWW Tools for troubleshooting 329
To Next Page
Loading...