4. Insert a piece of paper to activate the fuser (fixing) pressure-release sensor.
Figure 7-12 Test the fuser (fixing) pressure-release sensor (2 of 2)
5. Check the control-panel display for sensor response.
6. If there is no response, replace fuser (fixing) pressure-release sensor.
I primary transfer-roller disengagement sensor
1. Open the right door.
2. Lower the secondary transfer assembly.
3. Remove the ITB.
4. Rotate the gear (callout 1) to move the flag (callout 2). If the flag does not actuate, replace the ITB.
See
Intermediate transfer belt (ITB) on page 188.
Figure 7-13 Test the primary transfer-roller disengagement sensor (1 of 2)
1
2
330 Chapter 7 Solve problems ENWW
To Next Page
Loading...