2. Move the Tray 1 media-present sensor flag.
Figure 7-19 Test the Tray 1 media-present sensor
3. Check the control-panel display for sensor response.
4. If no response, replace Tray 1.
M Tray 2 paper out sensor
1. Remove Tray 2.
2. Move the tray 2 paper-out sensor flag.
Figure 7-20 Test the tray 2 paper-out sensor
3. Check the control-panel display for sensor response.
4. If there is no response, replace the tray 2 paper-out sensor.
ENWW Tools for troubleshooting 335
To Next Page
Loading...