Event log message Description Comments
3. Press the down arrow to highlight
PRINT QUALITY, and then press
the OK button.
4. Press the down arrow
to highlight
FULL CALIBRATE NOW, and then
press the OK button.
5. If the error persists, replace the
CPR sensor assembly.
6. Replace the ITB. See
Intermediate
transfer belt (ITB) on page 188.
55.06.01 The DC controller NVRM has an
abnormal read/write.
1. Turn the product off then on.
2. If the error persists, replace the DC
Controller. See
DC controller PCA
and tray on page 240.
55.06.02 The DC controller NVRM is not
accessible.
1. Turn the product off then on.
2. If the error persists, replace the DC
Controller. See
DC controller PCA
and tray on page 240.
55.901C DCC restored DCC NVRAM was restored from the
formatter.
61.00.01 Color table error This event occurs when the color table
cannot read a table from the disk and the
component reverts to the version in
RAM. The file could be corrupt, missing,
or the disk could have failed. No
messages display on the control panel.
67.XX.00 A system variable (XX) is out of range.
68 8X04 The permanent storage date does not
match the engine.
68 8X05 The permanent storage date does match
the engine.
Disk error: either the number does not
match or the write failed
99.00.01 No control panel message displays.
99.00.02 The firmware image has a CRC error.
99.00.03 A IO timeout occurred when reading the
header number and size.
99.00.04 A disk error occurred.
99.00.05 A IO timeout occurred when reading the
remaining header.
99.00.06 A IO timeout occurred when reading
image data.
99.00.07 An unexpected read error occurred when
reading the header number and size.
402 Chapter 7 Solve problems ENWW
To Next Page
Loading...