Federal Communications Commission Notice
Federal Communications Commission NoticeFederal Communications Commission Notice
Federal Communications Commission Notice
This equipment has been tested and found to comply with
the limits for a Class B digital device pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio or television
technician for help.
X-Ray Radiation Notice
X-Ray Radiation NoticeX-Ray Radiation Notice
X-Ray Radiation Notice
When operating, this product emits X-rays; however, it is
well shielded and meets the safety and health requirements
of various countries, such as the Radiation Act of Germany
and the Radiation Control for Health and Safety Act of the
United States.
Radiation emitted by this product is less than 0.1mR/hr (1
µ
Sv/hr) at a distance of 10 centimeters from the surface of
the cathode-ray tube. The x-ray radiation primarily
depends on the characteristics of the cathode-ray tube and
its associated low-voltage and high-voltage circuitry.
Internal controls have been adjusted to ensure safe
operation. Only qualified personnel should perform any
internal adjustments, as specified in the service manual for
this product.
Replace the cathode-ray tube with an identical CRT only.
Cables
CablesCables
Cables
Connections to this device must be made with shielded
cables with metallic REI/EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Canadian Notice
Canadian NoticeCanadian Notice
Canadian Notice
This Class B digital apparatus meets all requirements of the
Canadian Interference - Causing Equipment Regulations.
23
2323
23
Automatic Power Saving
Automatic Power SavingAutomatic Power Saving
Automatic Power Saving
To Next Page
Loading...
Need help?
General
