2-28 www.hp.com Hardware Reference Guide
Hardware Upgrades
6. Replace the removed drive bezel with the appropriate bezel by
pushing the bezel into place.
✎
The type of bezel you need will depend on the type of device you are
installing. If you are installing a diskette drive, you must install a
diskette drive bezel (PN 360189-001). If you are installing a hard
drive, you must install a bezel blank (PN 358797-001) as shown in the
illustration below. If you are installing a 3.5-inch device other than a
diskette drive or hard drive, you must install the 3.5-inch device bezel
(PN 358796-001). Contact an authorized HP reseller or service
provider to order the appropriate bezel when reconfiguring the
computer.
Installing a Drive Bezel (Bezel Blank for Hard Drive shown)
7. Replace the computer cover.
376293-002.book Page 28 Friday, February 18, 2005 3:02 PM
To Next Page
Loading...
