HP DC5100 User Manual

B-2 www.hp.com Hardware Reference Guide
Battery Replacement
Ä
CAUTION: Static electricity can damage the electronic components of
the computer or optional equipment. Before beginning these procedures,
ensure that you are discharged of static electricity by briefly touching a
grounded metal object.
1. Turn off the computer properly through the operating system,
then turn off any external devices. Disconnect the power cord
from the power outlet and disconnect any external devices. Then
remove the computer cover.
✎
It may be necessary to remove an expansion card to gain access to
the battery.
2. Locate the battery and battery holder on the system board.
3. Depending on the type of battery holder on the system board,
complete the following instructions to replace the battery.
Type 1
a. Lift the battery out of its holder.
Removing a Coin Cell Battery (Type 1)
b. Slide the replacement battery into position, positive side up.
The battery holder automatically secures the battery in the
proper position.
376293-002.book Page 2 Friday, February 18, 2005 3:02 PM

HP DC5100 Specifications

General

Processor	Intel Pentium 4 or Intel Celeron D
Memory	Up to 4 GB DDR2 SDRAM
Network	Integrated Broadcom NetXtreme Gigabit Ethernet
Operating System	Windows XP Professional
Chipset	Intel 915G Express
Graphics	Intel Graphics Media Accelerator 900
Optical Drive	DVD-ROM, CD-RW/DVD-ROM Combo, or DVD+/-RW
Ports	USB 2.0, serial, parallel, VGA, audio in/out
Audio	Integrated AC'97 audio
Expansion Slots	2 PCI, 1 PCI Express x1, 1 PCI Express x16
Form Factor	Microtower
Processor Speed	Up to 3.8 GHz
Storage	40 GB to 250 GB HDD