HP Designjet 130

HP Designjet 130/130nr Printer - Quick Reference Guide
29
English
The Problem is there is a Printhead Failure (continued)
...continued from previous page....
11.Push the printhead gently into place, so that it is secure.
12.Pull the printhead cover towards you, ensuring that the hook at its front edge
latches onto the tab, and then push it away from you to close the cover.
13.Plug in the printer power cable.
14.Close the rear part and then the front part of the outer flap. Note that after
closing the flap, the printer will automatically perform some internal
calibrations on the printhead, and then an alignment check. There must be
paper in the tray during alignment (you can use your least expensive paper).
Pre-alignment calibrations may take some time, especially if multiple
printheads have been removed and reinserted.Check that the alignment
print has a tick on it.
15.Check that the printhead icon on the front panel is no longer flashing. The
printhead has been replaced successfully.
If the problem persists, replace the printhead, as described in “How do I Clean
a Printhead? (continued)” on page 15.
QRG130.fm Page 29 Wednesday, February 11, 2004 3:28 PM