To Next PageTo Next Page
Need help?Do you have a question about the HP DesignJet 100 and is the answer not in the manual?
Print Technology| print technology | HP Thermal Inkjet |
|---|---|
| printhead nozzles | 300 |
| maximum resolution | 1200 x 600 dpi |
Print Speed| print speed A4 draft | 11 pages per minute |
|---|---|
| print speed A1 draft | 90 seconds per page |
| colour images speed | 25 sq m/hr |
Power| input voltage | 100 to 240 VAC |
|---|---|
| power frequency | 50/60 Hz |
| power consumption | 65 watts maximum |
Memory and System Requirements| memory | 16 MB |
|---|---|
| minimum system RAM for Windows 95/98 | 48 MB |
| recommended system RAM for Windows 95/98 | 64 MB |
Operating Environment| operating temperature range | 5 to 40° C |
|---|---|
| recommended operating temperature | 15 to 30° C |
| operating humidity range | 20 to 80% RH |
Dimensions and Weight| dimensions (w x d x h) | 1042 x 400 x 220 mm |
|---|---|
| product weight | 21 kg |
| maximum length of sheet media | 1625 mm |
Front panel cable, motor harness, encoder harness, and duplexer OOP sensor harness.
Front panel assembly and door sensor assembly for monitoring access.
JetDirect 615N internal print server LAN interface board with RJ-45 connector.
Main logic PC board module and various regional power cords.
Power supply module supporting 100V-240V input, 68W, 50/60Hz with fan.
Back/center cover, left cover assembly, and right cover assembly.
Main access door for printheads and carriage, and printhead door.
Standard capacity Cyan, Magenta, Yellow, and High Capacity Black ink cartridges.
Black, Cyan, Magenta, and Yellow ink printheads.
ISS rear/bottom absorbers, filter assembly, and ink supply station.
Cleanout interconnect PCA, OOPS sensor, and service station assembly.
Ink spittoon for residual ink and output mechanism support assembly.
Cam for input tray and paper input/output tray assemblies.
Transparency film, coated paper, and glossy InkJet brochure/flyer paper.
Various InkJet, InkJet Photo, Matte, and Photo papers in different finishes and sizes.
Carriage belt used to move the carriage and drive belt for output.
Carriage assembly, encoder strip, encoder strip holder, and paper motor encoder disk.
RIDS assembly, carriage drive motor, paper motor, and ramp motor.
Pick roller, feed roller, platens, paper guides, and pivot assembly.
Belt tensioner spring and turnaround assembly.
Base adaptor kit, paper bin assembly, and X-brace assembly for stand.
Foot assembly, legs assembly, and input tray support for the stand.
Diagram showing locations of duplex OPPS, motor, front panel, and encoder harnesses.
Diagram illustrating the printer's cover assemblies and filter assembly.
Diagram highlighting components on the left side of the printer.
Diagram showing components related to the scan-axis movement.
Diagram illustrating the paper feed assemblies, including input and output trays.
Diagram showing the rear paper path components like rollers and guides.
Diagram illustrating components along the top paper path.
Diagram showing the complete printer stand and paper bin configuration.
