HP DesignJet 500 - Page 7

13. Set up your Software (for Mac see next page)
Page 7
Note: If you want to use the ADI driver with the 500 plus series printer,
please select '500 + hp-gl/2' from the printer list.
Windows
Use the
‘Software setup’ CD
How will this printer
be connected to your
computer?
Connected via the network
Select the type of network Setup
1. Connect the printer to the network.
2. Make sure the printer is properly set up, turned on, and
ready to print.
3. Insert the HP Designjet Printers ‘Software Setup’ CD and
answer the questions. (If the CD does not start automatically,
run the ‘setup.exe’ program in its root folder).
1. Make sure the printer is properly set up, turned on, and
ready to print.
2. Make sure the printer is connected to your computer via
a parallel or USB cable (if using the USB cable, a
"Hardware Wizard" screen appears, press "Cancel")
and that all the cable connections are connected properly.
3. Insert the HP Designjet Printers ‘Software Setup’ CD and
answer the questions. (If the CD does not start
automatically, run the ‘setup.exe’ program in its root
folder).
4. Follow the instructions to complete the software setup.
The printer is already set up as a
shared device on the network and
is managed by a server or another
PC.
The printer will be set up
and managed directly over
the network by this computer.
Printer Your PC
Printer
Printer Printer Server
Printer
Your PC
Your PC
Connect directly to the computer
(parallel or USB cable)
4. When you get to the Network
Setup screen, select Client setup
for client-server printing.
4. When you get to the
Network Setup screen,
select Basic network
setup for a PC or server.
5. Follow the instructions to complete the
software setup.
Client Setup
Basic Network Setup
Your PC
HP DesignJet