56 Installing a New Roll on the Printer
3 Remove the blue colored stop from the end of the
spindle, and stand the spindle vertically, with the fixed
stop on the floor (see right).
4 Slide the new roll of paper on to the spindle. Make sure
the orientation of the paper is loaded exactly as shown.
If it is not, remove the roll, turn it through 180 degrees
vertically and slide it back on to the spindle.
5 Put the removable stop on to the upper end of the
spindle, and push it down as far as it will go.
Removable
Fixed
To Next Page
Loading...
