6 Removing Jammed Paper
10 Wait for the printer to finish initializing.
11 Press the Form Feed and Cut key on the
front panel to eject any small pieces of
paper that are still in the paper path.
12 Reload the paper as normal. If you are
using roll paper you may need to trim the
edge first, to ensure that it is straight.
Note If there is still paper left in the paper
path, try loading a sheet of stiff or rigid
paper into the printer, such as heavy
coated or matte film; this will help to force
out any paper jammed in the paper path.
13
If the cutter seems to be causing the
problem, check in the User’s Reference
Guide on the Using Your Printer CD that
the type of paper is supported by the
printer. Try disabling the cutter from the
front panel; use → Cutter → Off.
14 You are strongly recommended to use the
Align Printheads procedure (see page 44
on the reverse of this Pocket Guide) after
clearing a paper jam, as the problem may
have caused the printheads to be
misaligned. (Select → Align
Printheads → Standard alignment.)
Note that you do not have to interpret the
patterns printed by the Printhead
Alignment routine.
To Next Page
Loading...
