22 Advance Calibration Routine
Advance Calibration Routine
It is important that the paper loaded for this calibration is
exactly that used for normal printing, both in quality (for
example, glossy paper) and in width (for example, A0 or
36-inch). Either roll or sheet paper can be used.
The routine prints a pattern and then cuts the roll or
ejects the sheet; it requires paper that is at least 65 cm
long and at least 50 cm wide. You must then reload that
piece of paper as a sheet, so that the printer can
accurately measure the pattern, and make whatever
adjustments are appropriate to the amount it advances
between printing swaths of data. (See page 47, “Load a
Sheet of Paper” on the reverse of this Pocket Guide.)
The pattern printed is solely for the use of the printer;
you are not expected to relate any of its characteristics
to the quality of your images.
1 From the main front-panel menu, with the correct
paper loaded, select the Paper menu ( ) and
press Enter.
2 Select Advance
calibration and press
Enter.
3 Select Create pattern and
press Enter. The printer
prints its calibration pattern
(as represented opposite)
and cuts or ejects the paper.
To Next Page
Loading...
