HP Designjet T1100

HP Designjet T Series — Service Manual 6-27
Removal and Installation - Right Cover
Right Cover
Removal
1. Remove the Front Cover on page 6-16.
2. Open the Right Ink Cartridge Door by
applying sharp pressure to the right
side of the door and lifting firmly where
the door meets the Right Cover. Use your
hands. When the door is unclipped from
the pressure applied to the right side of the
door, you will hear a sound that
corresponds to the clip.
Do NOT use a screwdriver or other
tool to open the Right Ink Cartridge
Door.
3. Remove one T-15 screw that secures the
Right Cover to the printer (at the rear of the
Printer).
4. Remove one T-15 screw that secures the
Right Cover to the printer (at the rear of the
Printer).
Switch off the printer and remove the power cable.