HP Designjet T1100

HP Designjet T Series — Service Manual 6-43
Removal and Installation - Right Rear Tray Support
Right Rear Tray Support
Removal
1. Remove the Rear Tray on page 6-35.
2. Re
move the Right Cover on page 6-27.
3. Re
move the Left Cover on page 6-30.
4. Re
move the Rear Cover on page 6-36.
5. Remove two T-15 screws that secure the
Right Rear Tray Support to the printer.
6. Rotate the Right Rear Tray Support
counterclockwise approximately 30
degrees.
Switch off the printer and remove the power cable.