HP Designjet T1100

HP Designjet T Series — Service Manual 6-45
Removal and Installation - Left Rear Tray Support
Left Rear Tray Support
Removal
1. Remove the Rear Tray on page 6-35.
2. Re
move the Right Cover on page 6-27.
3. Re
move the Left Cover on page 6-30.
4. Re
move the Rear Cover on page 6-36.
5. Remove two T-15 screws that secure the Left
Rear Tray Support to the printer.
6. Rotate the Left Rear Tray Support clockwise
approximately 30 degrees.
Switch off the printer and remove the power cable.