HP Designjet T1100

6-74 HP Designjet T Series — Service Manual
Removal and Installation
4. Remove the three T-15 screws that secure
the PrintMech PCA to the Service Station.
5. Remove the PrintMech PCA from the
printer.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
44 inch T1100 printer shown (with Rewinder)
44 inch T1100 printer shown (with Rewinder)