HP Designjet T1100

6-116 HP Designjet T Series — Service Manual
Removal and Installation
Carriage Assembly (T1100/T1100ps/T610)
Removal
1. Remove the Front Cover on page 6-16.
2. Re
move the Right Cover on page 6-27.
3. Re
move the Left Cover on page 6-30.
4. Re
move the Cutter Assembly on page 6-
42.
5. Re
move the Front Panel on page 6-47.
6. Re
move the Top Cover on page 6-50.
7. Re
move the Window Position Sensor on
page 6-53.
8. Re
move the Ink Supply Tubes Support Rail
(T1100/T1100ps/T610) on page 6-55.
9. Manuall
y uncap the Service Station.
10. Re
move the Encoder Strip, spring and
attachment nut (T1120/T1120ps) on page
6-99.
11. If
necessary manually move the Carriage
Assembly fully right into the docking
station.
12. Use a short torx screwdriver to remove the
two T-10 screws that secure the center
attachment of the Trailing Cables.
Switch off the printer and remove the power cable.
If you replace the Carriage Assembly with service parts Q6683-60231
(24 inch) or Q6687-60087 (44 inch) that include a Trailing Cable, remember
to remove the Trailing Cable with the Carriage Assembly.